Up to Date NYS Inspection and Registration
New engine (152,212 miles)
Battery
Starter
Water pump
Radiator
All hoses for heating system
Complete A/C system and new retrofit
Gas tank
Muffler system and piping-stainless steel muffler (dual exhaust)
Gas, brake and A/C lines
Blower motor
Heater Core
In-line thermostat
Onboard computer
Front and rear brakes
Wheel bearings
Alternator
Fuel pump and filter
NOTE: all body parts were undercoated before installation
Front fenders
Rear quarter panels
Rocker panels
Door column supports strut
Front headlight support assembly
Two steel patches under both front wheels
New steel and fiberglass on trunk wall beneath bumper
Repaired existing dent on trunk spoiler
Passenger door (used-rust free)
Door skin only on driver’s side door and new lower hinge
Gasket material on both doors plus trunk
Original Z24 Stock Wheels
Original Z24 center caps for wheels
New Tires
Steam clean undercarriage, apply rust eliminator and final undercoat by Ziebart
2 coats of zinc oxide primer over bare metal
4 coats of gray primer-sanded between coats
6 coats of GM "Dark Red Metallic"
4 coats of clear silicone sealer - wet sanding between coats
Repaint of all black components on exterior-windows, wipers, spoiler, locks, antenna, etc.
Repaint of side spoiler and new logo
Repaint of both bumper and grille assemblies and new Chevy emblem on front grille
Adjustment of headlights
Mud flaps
New door handle-driver’s side
Ziebart undercoat process under car
Ziebart Diamond Gloss paint and windshield protection
New interior components:
Carpet
Headliner
Trim for radio/A/C units with cassette tape inserts
New custom made armrest on console
Repaint all console components, all interior pieces including dashboard, parking brake, gearshift handle, window and headliner trim, door cranks, seat belt covers, door arm rests, ashtray components, rocker panel cover retainers, glove box and door
Reupholster both bucket seats, rear bench seat and both side door panels to match original - repaired driver’s seat (welding)
Z24 Nameplates on both inside doors
Carpet and repaint in trunk area and rubber coating on metal floor
Seat tracks for driver’s side
Restore passenger seat tracks-bead blast and repaint (primer and finish coat)
Rubber coating on painted floor before carpet install
Security system Level 2
Keyless entry-new door solenoids
Remote starter
AM/FM/CD player by Pioneer
Power trunk opener-solenoid and pushbutton are GM parts
New license plates
Complete doll up of interior and exterior after everything has been installed
